ARM AND HAMMER ANVIL SERIAL NUMBERS SKIN

You can either polish by hand or by machine. This is very noisy!Д®ven bright mild steel comes with a protective coating, to stop it instantly rusting, which has to be removed to achieve that bright polished look. Dishing can be done onto a flat metal surface, such as the face of an anvil.

A selection of hammers, with different curves to their faces makes life easier. If your surface is uneven either finish it off by doing a final pass on a flat surface or by planishing (see later). If the edges start to crinkle, flatten them out immediately over a former with a flatfaced hammer (otherwise the metal may crack). If the piece starts to bend dramatically, in a fashion you donвЂ™t want, straighten it out either by putting it in the vice and pulling or by hitting it over a stake with a flat-faced hammer. On each pass (time round the entire piece) try to even out the hammer marks from the previous pass. IвЂ™ve seen it done - ouch! Work evenly around the shape. What ever you do donвЂ™t put your hand between the block and the bit you are about to hit. Holding the piece in a glove cuts down the vibrations to your hand, ear defenders cut down the noise to your ears. Place the piece over your dishing hole and start hammering around your guidelines. To dish a piece first mark some guide lines when you start you may want to draw lots of concentric lines, when you get more experienced you may just want to mark the centre. One says work from the outside in, the other says work from the middle out I find it makes no difference. There are two theories of dishing depending on whether you are a Tinsmith or a Silversmith. This is in essence what you are going to do with your piece of steel using a hammer and a dishing block. If you push it into a bowl shaped former it is even easier to form it. Think of a piece of clay if you push your thumb into it a number of times you can squeeze it out into a bowl shape. Use a soft mallet to avoid marking the metal.

Now hammer it some more, push it with your hand, and hammer it back if you have gone too far, until you reach the desired shape. DonвЂ™t worry unduly about how much just get the metal moving. Long bends are best achieved by hammering down over a former a bit of metal tube, a log, pipe, stake, whatever - provided itвЂ™s curved. ItвЂ™s very easy to push a bit a metal and bend it at that point what is trickier is to get a curve over the entire length.

ARM AND HAMMER ANVIL SERIAL NUMBERS SKIN

Remember this is the inside of your armour - you want something smooth and relatively flat pointing at your skin donвЂ™t you? Smooth out the pein using the flat face of the hammer. Now using the ballД®nd of the hammer hit the top of the exposed shank to mushroom it. Place the head down onto a hard flat surface, into a rivet snap or into a cut out that matches its head. Peining simply involves hammering the end of the rivet to form a second head - bring on the ball pein hammer! Place the rivet through the holes in your pieces with the head on the out. A leather washer between the two plates surfaces has several purposes, it holds the two moving surfaces apart giving them room to move, stops the rivet falling out (if its a tight fit on the shank) when you turn everything over for peining and allows you to keep the rivet loose without rattling. The first is to hold things firmly together, as on a helmet, the other is to form a pivot, as in an articulated knee.ДЇor a firm fit drill a hole in both pieces the same diameter as your rivet then pein the rivet fully down to the inner plate.ДЇor an articulation make the hole one size bigger than the rivet and pein the head over lightly.

Arm and hammer anvil serial numbers